Pull Out And Turning Handle for Sectional Steel Rods Size:5/16" you are assured of getting

you are assured of getting a tool that is rotating concentrically down the pipe

They are designed for you units for flow from 40 to 170 gpm and pressures to 3000 psi

- 5" Diameter

they are sanded smooth and then oiled for protection

Once you get to the correct level to enter the pipe just lift the rope and the bridge slowly becomes horizontal so you can lift it and slide it into place in the line

Pull Out And Turning Handle for Sectional Steel Rods Size:5/16" you are assured of gettingThis tool you can use to push, pull or turn the rods. You can slide this tool right over the rod and it will slip over the coupling to allow you to push or pull the sectional rods. Insert the pin through the center hole of the coupling and you can turn the rods too. This is done with hand rodding. Pick for either your 5 16 or 3 8 rods. Made of steel and zinc plated.