Tork Craft | Annular Hole Cutter HSS 40 X 30mm Broach Slugger Bit Shipping_600 or they run across the

or they run across the grain

precision-ground carbide teeth and a Teflon-coating ‘Perma-SHIELD protection’

Drill diameter: Ø4

Apply two thin coats with an Osmo Floor Brush or Osmo Natural Bristle Brush for smaller areas

Cutting a plastic pipe to length

Tork Craft | Annular Hole Cutter HSS 40 X 30mm Broach Slugger Bit Shipping_600 or they run across theAnnular Hole Cutter HSS 40 X 30mm Broach Slugger Bit One way to avoid dimpling and deburring while making holes in tube and pipe is to use annular cutters. Because annular cutters are hollow on the inside, there is no dead zone resistance to overcome. Using a twist drill to make holes in pipe or tubing can prompt concerns about the hole roundness, location accuracy, hole finish, chip extraction, burrs, and drilling duration. The focal point of these